825 500Watt Electric Chopper
Description
Send to friend
Reviews
Start: Keyed Electric start. Just turn the key and rotate the right throttle to go. It doesn't get any easier than this.
Speed: Up to 17mph. Very similar to that of a bicycle.
Parts: We have a full stock of parts for this model. The quality is as good as it can be, we have been selling the same model for 5 years.
Headlight: Single headlight
Front and Rear Turn Signals: Front are located next to headlight. Rear are located directly behind the seat in the back.
Rear brake light
Rubber tires: Front: 13" x 4" x 5" (height x inside diameter x outside diameter)
Rear: 13" x 6.5" x 6" (height x inside diameter x outside diameter)
Charger port + Charger: Every Electric chopper comes with a 24 volt charger. It takes 3-6 hours to fully recharge the battery. When the light on the charger changes from red to green, it is done charging. One charge will last you for 2-3 hours of stop and go use. If you ride on it continuously at full speed, the charge will last about 45 minutes, but most people use it for stop and go use like going to the grocery store or to a friends house. The electric scooters are supposed to go for around 300 charges before you will have to replace the batteries. Of course leaving the lights on in-between uses will shorten this time just like it does your car battery.
Rear Sissy Bar w/ Backrest
Padded Seat: Thick padded seat with coil springs under it for a very comfortable ride.
Brakes: Front and Rear Disc brakes. Brakes are controlled by the left and right handle bar levers.
Controls on the handle bars: Turn signal switch, headlight switch, horn, LED speed indicator and LED battery charge indicator.
How much Weight will it hold: 200+ pounds
Weight of unit: 115 pounds
Dimensions: 60" x 12" x 40" (length x width x handle bar height).
Ground Clearance: 4.5"
Features: Rear brake light, Street tires, kickstand, adjustable sissy bar with backrest.
Assembly: Usually takes only 30 minutes. The electric choppers are completely assembled in the factory and fully tested. After testing, the tires (the wheels are already attached to the tires), sissy bar and handle bar assembly are removed. All you have to do is put them back on. the handle bar assembly attaches with a bracket and 4 bolts. You will also have to put the bolt through to secure the top of the rear shock.
? Maintenance: Look in local yellow pages for lawn mower repair or small engine repair (You can also call us and we can suggest one by looking it up on http://www.local.google.com/ and clicking find businesses). These dirt bikes are similar to other small engines and can easily be repaired by these people. All they need to do is to call us up and we can furnish the parts needed.
No posts found
Add new post